Corrected Sodium Calculator
Enter measured sodium and blood glucose to get corrected sodium using the Katz and Hillier formulas for hyperglycemia.
Corrected sodium is calculated as measured Na + factor × (glucose − 100) ÷ 100, with glucose in mg/dL. Using the Hillier factor of 2.4, a sodium of 130 mEq/L and glucose of 600 mg/dL gives a corrected sodium of 142 mEq/L; the Katz factor of 1.6 gives 138 mEq/L.
Free, runs in your browser. Nothing you enter is uploaded.
How to use it
- Enter the measured sodium level in mEq/L.
- Enter the blood glucose level in mg/dL.
- Read corrected sodium values using both the Katz and Hillier formulas.
- Interpret results: if corrected sodium is normal or high, consider 0.45% NaCl; if low, use 0.9% NaCl (per ADA guidelines).
What you enter
- Measured Sodium (mEq/L)
- Blood Glucose (mg/dL)
What you get
- Corrected Sodium (Katz)
- Corrected Sodium (Hillier)
- Effective Osmolality (Tonicity)
Formula
Katz: Na + 1.6 × (glucose − 100) ÷ 100 | Hillier: Na + 2.4 × (glucose − 100) ÷ 100 | Effective osmolality = 2 × Na + glucose ÷ 18 (mg/dL)
Hyperglycemia causes translocational hyponatremia because glucose is an effective osmole that draws water out of cells, diluting the sodium in the bloodstream. The corrected sodium estimates what the sodium concentration would be if the glucose level were normal, revealing the patient’s true sodium status.
The general formula is: Corrected Na = measured Na + factor × (glucose − 100) ÷ 100, where glucose is in mg/dL. If glucose is measured in mmol/L, multiply by 18.016 to convert to mg/dL. The factor accounts for the osmotic effect of glucose. Two factors are commonly used: the theoretical Katz factor of 1.6 (1973) and the empirically measured Hillier factor of 2.4 (1999). The Hillier factor was derived from volunteers given somatostatin and dextrose and provides a better overall fit, especially when glucose exceeds 400 mg/dL.
In clinical practice, corrected sodium guides fluid choice in diabetic ketoacidosis (DKA) and hyperosmolar hyperglycemic state (HHS). According to ADA guidelines, if the corrected sodium is normal or high, use 0.45% NaCl; if it is low, use 0.9% NaCl. Additionally, effective osmolality (tonicity) can be calculated as 2 × Na + glucose/18, excluding urea. In HHS, tonicity is typically greater than 320 mOsm/kg.
This correction applies only to hyperglycemia-induced hyponatremia. It is not appropriate for pseudohyponatremia caused by elevated lipids or proteins, which is a laboratory artifact unrelated to osmotic shifts.
Worked example
Input: Na 130, glucose 600 mg/dL
Result: Hillier 142; Katz 138 mEq/L; tonicity about 293 mOsm/kg
The low sodium is mostly from glucose drawing water out of cells.
Questions
What is the formula for corrected sodium in hyperglycemia?
Corrected Na = measured Na + factor × (glucose − 100) ÷ 100, with glucose in mg/dL. The factor is 1.6 (Katz) or 2.4 (Hillier). Hillier's factor is more accurate, especially when glucose exceeds 400 mg/dL.
Why does hyperglycemia cause hyponatremia?
High glucose acts as an effective osmole, drawing water out of cells into the bloodstream. This dilutes the sodium concentration, causing translocational hyponatremia. Corrected sodium estimates the true sodium status.
When should I use the Katz vs. Hillier correction factor?
The Katz factor (1.6) is theoretical, while the Hillier factor (2.4) was measured in human volunteers and provides a better fit, particularly for glucose levels above 400 mg/dL. Most clinicians now prefer the Hillier factor.
How does corrected sodium guide fluid therapy in DKA?
According to ADA guidelines, if corrected sodium is normal or high, use 0.45% NaCl; if corrected sodium is low, use 0.9% NaCl. This helps avoid rapid shifts in osmolality.
What is the difference between corrected sodium and effective osmolality?
Corrected sodium adjusts for glucose-induced dilution. Effective osmolality (tonicity) = 2 × Na + glucose/18, excluding urea. It measures the osmotic gradient across cell membranes; in HHS it is typically >320 mOsm/kg.
Can this calculator be used for pseudohyponatremia?
No. Pseudohyponatremia is a lab artefact caused by high lipids or proteins, not by osmotic shifts. This calculator only corrects for hyperglycemia-induced hyponatremia.
Limitations
- The Katz factor is theoretical and may underestimate the correction, especially at very high glucose levels.
- The Hillier factor was derived from a small study in volunteers and may not apply to all patient populations.
- This correction is not valid for pseudohyponatremia due to hyperlipidemia or hyperproteinemia.
- Always interpret corrected sodium in the context of the patient's overall clinical picture and fluid status.
References
- Katz MA (1973) Hyperglycemia-induced hyponatremia: calculation of expected serum sodium depression. NEJM 289:843–844
- Hillier TA, Abbott RD, Barrett EJ (1999) Hyponatremia: evaluating the correction factor for hyperglycemia. Am J Med 106(4):399–403
- Kitabchi AE et al. (2009) Hyperglycemic crises in adult patients with diabetes. Diabetes Care 32(7):1335–1343
More Health & Wellness
- BMI Calculator & Medical Ideal Body Weight (IBW) Planner
- Body Fat Percentage Calculator & Lean Mass Index
- Body Surface Area (BSA) Calculator
- Calorie Deficit Calculator & Target Goal Date Planner
- Ovulation Calculator & Period Tracker
- One Rep Max Calculator (1RM)
- BMR Calculator (Basal Metabolic Rate)
- Blood Alcohol Calculator (BAC)
- Sleep Calculator (Bedtime and Wake-Up Times)
- Pace Calculator (Running Pace, Time and Distance)
- eGFR Calculator (CKD-EPI 2021)
- Protein Intake Calculator
All free tools · By Dr. Zubair Khalid, DVM, MS, PhD.